Proposal of a Test Bench for Switched Reluctance Machine 8/6 for Wind Energy Application

Authors

  • R.T. Fidelis Author
  • G.P.Viajante Author
  • L.C. Gomes Author
  • D. A. Andrade Author
  • E.N.Chaves Author
  • M.A.A.Freitas Author
  • C.C. Vieira Author
  • M.J.M.Filho Author

DOI:

https://doi.org/10.24084/repqj16.359

Keywords:

Generator, Switched Reluctance Machine, Wind Power, Workbench

Abstract

This paper presents a Switched Reluctance Machine (SRM) dynamic performance analysis under various operating conditions. Thus, an SRM 8/6 was designed and built and a new bench was built to drive it, aiming to study the drive techniques and generated voltage control techniques for use in small wind turbine generators. The driving was done through a data acquisition and processing system of high performance and low cost (DSP / FPGA). The experimental results are shown and discussed.

Author Biographies

  • R.T. Fidelis

    National Industrial Learning Service SENAI 
    Itumbiara -  Goiás, (Brazil) 

  • G.P.Viajante

    Federal Institute of Education, Science and Technology of Goiás 
    Campus of Itumbiara – Goiás, (Brazil)

  • L.C. Gomes

    Electric Drives Laboratory, Federal University of Uberlândia 
    Campus Santa Mônica, Uberlândia-MG, Brasil.

  • D. A. Andrade

    Electric Drives Laboratory, Federal University of Uberlândia 
    Campus Santa Mônica, Uberlândia-MG, Brasil

  • E.N.Chaves

    Federal Institute of Education, Science and Technology of Goiás 
    Campus of Itumbiara – Goiás, (Brazil)

  • M.A.A.Freitas

    Federal Institute of Education, Science and Technology of Goiás 
    Campus of Itumbiara – Goiás, (Brazil) 

  • C.C. Vieira

    National Industrial Learning Service SENAI 
    Itumbiara -  Goiás, (Brazil) 

  • M.J.M.Filho

    Electric Drives Laboratory, Federal University of Uberlândia 
    Campus Santa Mônica, Uberlândia-MG, Brasil.

Downloads

Published

2024-01-24

Issue

Vol. 16 No. 4 (2018)

Section

Articles