Power electronics applied to voltage control in rural distribution networks with penetration of distributed generation

Abstract

In rural distribution networks with widely dispersed loads, characterized by the utilization of long overhead lines, voltage profiles with big variations appear along the line due to the significant variations of the load between peak hours and valley hours. This paper describes the problems that the integration of distributed generation based on renewable resources could generate in that scenario, and presents solutions that are commonly used to mitigate these problems and proposes new solutions to solve them. The integration of distributed generation (DG) based on renewable resources in these networks increases the variability of the voltage, and in some cases the power flow of the network also can be bidirectional. Usually this integration of distributed generation is limited by the network operator limiting the maximum voltage variation produced by the distributed generation in the point of common coupling (PCC). In this paper different traditional methods for voltage control are described and analyzed for a widely dispersed rural network scenario. The impact of the DG in these methods of voltage control and the advantages of power electronics in this new scenario are exposed. Power Electronic devices applied to these distribution networks allow more efficient management of the network increasing the integration of distributed generation maintaining the security levels.