Engine performance of a single cylinder direct injection diesel engine fuelled with blends of Jatropha Curcas oil and standard diesel fuel

Authors

  • R. Piloto Author
  • M. Errast Author
  • N.Ferrer Author
  • E. Melo Author
  • L. Goyos Author
  • S. Verhelst Author

DOI:

https://doi.org/10.24084/repqj11.225

Keywords:

Jatropha curcas, blends, ignition, ignition delay, diesel engine

Abstract

Blends of Jatropha Curcas oil and standard diesel fuel were evaluated (without pre-heating). The engine tests for the blends were performed in a Petter single cylinder direct injection diesel engine under steady state conditions at high loads. Engine speeds between 1300-1700 rpm were selected for the engine tests. Torque, power output, specific fuel consumption, in cylinder pressure, ignition delay, rate of heat released and exhaust composition were evaluated. The tested blends between 10-20% of oil shown lower effective torque and power output joint to a higher specific fuel consumption related to the lower heating value of Jatropha oil compared to diesel fuel. Lower pressure peaks and rates or pressure rises were observed when Jatropha blends are used. A decrease in the rate of heat released and shorter ignition delay were observed for the blends. Decreases in HCand CO emissions were observed for blends compared to diesel fuel. Both alternatives assessed shown that the differences observed compared to diesel fuel, can be partially restored with engines regulation. The use of Jatropha oil in order to be a partial or full alternative to the use of diesel fuel for energy production was achieved.

Author Biographies

  • R. Piloto

    Faculty of Mechanical Engineering, Technical University of Havana. Cuba

  • M. Errast

    Faculty of Mechanical Engineering, Technical University of Havana. Cuba

  • N.Ferrer

    Faculty of Mechanical Engineering, Technical University of Havana. Cuba

  • E. Melo

    Faculty of Mechanical Engineering, Technical University of Havana. Cuba

  • L. Goyos

    Faculty of Mechanical Engineering, Technical University of Havana. Cuba

  • S. Verhelst

    Department of Flow, Heat and Combustion Mechanics, Faculty of Engineering, Ghent University. Belgium

Downloads

Published

2024-01-24

Issue

Section

Articles