Modelling, Iterative Procedure and Simulation Results for a Monocrystalline Solar Cell

Authors

  • S. Saraiva University of Beira Interior and CAST Author
  • R. Melício University of Beira Interior and CAST ;Center for Innovation in Electrical and Energy Engineering, Instituto Superior Técnico Author
  • J.C.O. Matias University of Beira Interior and CAST Author
  • C.M.P. Cabrita University of Beira Interior and CAST Author
  • J.P.S. Catalão University of Beira Interior and CAST ;Center for Innovation in Electrical and Energy Engineering, Instituto Superior Técnico Author

DOI:

https://doi.org/10.24084/repqj10.375

Keywords:

Photovoltaic energy, solar cells, modelling, simulation, iterative procedure

Abstract

This paper focuses on the modelling and simulation for a photovoltaic system formed by monocrystalline solar modules. The objective is to find the parameters of the nonlinear I-V equation by adjusting the curve at three points: open circuit, maximum power, and short circuit. This paper brings a novel iterative procedure to find the value of diode ideality factor, series and equivalent shunt resistances. Simulation studies are carried out in order to uncover temperature dependence, solar radiation change, and output power variation. Finally, conclusions are duly drawn.

Downloads

Published

2024-01-16

Issue

Vol. 10 No. 4 (2012)

Section

Articles